Pre-Installed Sealed Beam HeadlightUpdated 6 months ago

Length of Warranty:

1-Year Warranty

Important Product Information:

• For a comprehensive overview of your product, you can find more details by visiting this link: Oracle Sealed Beam Headlights.

Fitment Information:

• If you're upgrading from sealed beam lights to H4 LED headlight bulbs with 3 prongs, you have three options:

  1. Hardwire the bulb to the factory plug.

  2. Slide female spades over the 2 vertical pins and tap into the factory plug.

  3. Our suggested method: Chop off the top horizontal pin and plug the bulb in.

• If you need to trim the buckets for fitment, please refer to this video guide: Fitment Guide.

Wiring Information:

• Wiring suggestions depend on the product's color:

  • White: Wire to the parking light or ignition.

  • Amber: Wire to parking and ignition, using a Dual Intensity Circuit for Turn Signal & Parking Light.

  • Any other color: Wire to a switch or remote (please be aware that this may not be street-legal in most areas).

  • ColorShift: Requires the use of a ColorShift controller, which is sold separately.

• For vehicles manufactured before 2007 (excluding obscure German makes), you won't need CAN-BUS adapters. Simply follow the provided diagram for installation.

Troubleshooting:

• If you experience LED failures, there's no need for troubleshooting. You can proceed to process a warranty claim, as outlined below.

• In the case of LED Driver failure, it can be replaced at no charge, provided you follow the troubleshooting process.

• If you encounter water damage or moisture issues, it's essential to use the rubber back cap to prevent water ingress; otherwise, your warranty may be voided.